Jay-d will not turn on after programing

everything was working fine, but after the programing tutorial it won’t turn on.

after getting through the programing tutorial, which was extremely difficult. I am very new to programing which was my main reason for getting this kit but so many configurations and installation steps are skipped over it was a challenge to say the least.

I uploaded the program to the jay-d and vs code said it was a sucess but now it won’t turn on. my computer recognizes the device but none of the lights or the screen works now. tried plugging it into the wall but still nothing.

Hey @bk1027, thank you for reaching out to us here on the forum.
Please try to restore the firmware using these instructions.
Hope this helps.

Cheers,
Luka